Automatic notch filters work by identifying carriers near the receive frequency and applying a notch filter to cancel them. They can sometimes misidentify a desired CW signal as being undesirable and notch it out as well.

Last edited by scoopgracie. Register to edit

Tags: none

DSP noise reduction operates by examining a characteristic of signals and noise called correlation and dynamically filtering out the undesired noise. Correlation is a measure of the “regularity” of a signal. In most DSP noise blanker implementations, the amount of noise reduction varies according to the correlation characteristics of the noise. Random noise such as white noise or static is uncorrelated. Speech and ignition noise is moderately correlated. Heterodynes and pure tones are highly correlated.

Last edited by marvsherman419. Register to edit

Tags: arrl chapter 7 arrl module 7e

Answer: Signals which appear across a wide bandwidth

Think of lightning. It is a signal which covers a wide bandwidth as it can be heard in AM or SSB modes on receivers across many frequencies/bands. Noise Blanker helps to eliminate this.

Other wide bandwidth signals include automobile spark plugs, electric motors, generators, or alternators with armatures, electric switches, or anything else that produce sparks.

Memory tip: read "blanker," think blanket. Blankets are wide.

Last edited by k7kdg. Register to edit

Tags: arrl chapter 7 arrl module 7e

Connecting leads directly to the battery bypasses many sources of noise currents that flow through the car. The battery also absorbs voltage spikes and some noise from the alternator. If this is not sufficient, then adding additional capacitors across the alternator, or a "coaxial capacitor" in line with its leads, will absorb even higher frequency noise before it gets to the battery.

The other three answers all mention putting a capacitor or high-pass filter in series with the radio's power leads. Capacitors block DC from flowing and thus the radio would not power on. Note that coaxial capacitors are different; they are inline but they are not in series.

Memory Tip: the correct answer is the only one with the word "alternator" in it.

Last edited by ky4me. Register to edit

Tags: arrl chapter 7 arrl module 7e

A Brute Force filter is a ham "slang" term. The term refers to any large, well shielded filter. The answer to this question is easy to remember just remember "Brute Force".

An example of the kind of filter this question is referring to would be: http://www.digikey.com/product-detail/en/20DRGG5/603-1147-ND/1718592

Mind Tickler: Only one answer has the term AC in it.

Last edited by kf4ty. Register to edit

Tags: arrl chapter 7 arrl module 7e

A computer is full of digital signals. From an RF point of view these are square waves rich in harmonics, hence the large numbers of specific frequencies.

Hint or method to remember the answer: Some hams refer to this noise as "birdies" on the band, which can describe the bird-like sound generated when you spin across the band and go past the frequency where this computer (man-made) noise is being generated.

Last edited by flyguystudy. Register to edit

Tags: arrl chapter 7 arrl module 7e

TIP: To radiate, there has to be current conducting somewhere. All answers have shield, but only the correct mentions currents and conductors.

Good currents flow from a source out to a load and back through the same cable to return to the source. This is called "differential-mode current" -- the current going out and coming back is in balance and contained safely within the shield and can neither radiate out, nor be affected by noise coming in.

Common-mode current flows on the outside of the shield. Since the shield is a single conductor, something else is needed to complete a circuit -- usually through your safety earth connection or somewhere else undesirable. This unintended circuit occupies a big area which makes a nice loop antenna to radiate and absorb noise.

The other three options are all good practice to prevent ground loops and other noise problems, and prevent (not cause) radiated interference.

Last edited by kermitjr. Register to edit

Tags: arrl chapter 7 arrl module 7e

Common-mode current flows equally on all conductors of an unshielded multi-conductor cable.

In the question, "equally" in this case means "same direction" more than "same amount." Ideally the same current that flows to your antenna in one conductor returns from your antenna in the other. This is known as differential-mode current.

If some of the current that flows to your antenna in one conductor also flows to your antenna in the other, it is known as common-mode current. -- qubit

Common-mode current is often caused by strong signals being picked up by antenna, television, telephone, or power wiring. These signals can be significantly reduced using a common mode choke by winding several turns of the wire around a ferrite toroid core with the ferrite type being selected to match the frequency of the common-mode current.

Hint: Common is only in the correct answer.

Last edited by katzelover. Register to edit

Tags: arrl chapter 7 arrl module 7e

When the receiver's noise blanker is turned on and/or set to maximum, strong signals on nearby frequencies may be heard on your frequency as noise or chatter. The audible effect is similar to "splatter," which is sometimes heard when a station operates an improperly adjusted transmitter and generates a signal with excessive bandwidth.

Cheat: IF. Only the correct answer has the word "if" in it.

Last edited by dwage@dwage.com. Register to edit

Tags: arrl chapter 7 arrl module 7e

To eliminate this would require some detective work. Regularity and the times that the problem occurs would provide clues. If it was frequent enough, the old trick of switching off your main house breaker would tell you if it is on your property.

Last edited by marvsherman419. Register to edit

Tags: arrl chapter 7 arrl module 7e

Strong AM signals such as those from local broadcast stations can be detected or mixed by any kind of non-linear junction, from a diode to even a rusty bolt, much like the old-school cat's whisker detector.

Broadcast stations are regularly monitored and would notice any kind of abnormal transmission, so a mistake on their part is highly unlikely.

Silly Hint: AM (music) - Look for answer with Metal (band).... aka Metallica...

Last edited by robertov416. Register to edit

Tags: arrl chapter 7 arrl module 7e